Dinamap Pro 100V2 Wartungshandbuch PDF herunterladen (Seite 31)

Revision A PRO 100-400 V2 Patient Monitor Service Manual 2-9

2009829-001

Product Description: SECTION 2. PRODUCT DESCRIPTION

2.4. HOST PORT CONNECTOR (REAR PANEL)

WARNING! Auxiliary equipment connected to

the DINAMAP

PRO Series Monitor will result in

the formation of an electromedical system and

thus, must comply with the requirements of EN

60601-1-1/ IEC 601-1. All host port signals are

NON-ISOLATED and should be connected to

equipment conforming to IEC-601-1, configured

to comply with IEC 601-1-1 ONLY. Where isolation of data

communication is required, GE Medical Systems Information

Technologies part number ILC232 should be used. If external alarm

control is required, GE Medical Systems Information Technologies

part number 487208 (Isolated Remote Alarm Cable Assembly) should

ALWAYS be used. Please refer to the Information Sheet included

with the isolated remote alarm cable for details.

Note: When using remote alarm, the PRO Series Monitor should be

considered the primary alarm source. The secondary alarm is used

for secondary purposes only.

Pin Assignments

Pin Function

1 Ground

2 Inverted TTL Transmit Data

3 Inverted TTL Receive Data

4 Fused +5 Volts

5 No connection

6 No connection

7 Ground

8 Remote Alarm

9 RS232 Request to Send (RTS)

10 RS232 Clear to Send (CTS)

11 RS232 Transmit Data (TxD)

12 No connection

13 RS232 Receive Data (RxD)

14 No connection

15 No connection

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 103 104

Keine Kommentare

Dinamap Pro 100V2 Wartungshandbuch Seite 31