Dinamap Pro 100V2 Spezifikationen PDF herunterladen (Seite 26)

produce a peripheral pulse or the patient may have

poor peripheral perfusion. Also, if a patient’s beat-to-

beat pulse amplitude varies significantly (e.g., because

of pulsus alternans, atrial fibrillation, or the use of a

rapid-cycling artificial ventilator), blood pressure and

pulse rate readings can be erratic, and an alternate

measuring method should be used for confirmation.

General Notes

• A patient’s vital signs may vary dramatically during the

use of cardiovascular agents such as those that raise or

lower blood pressure or those that increase or decrease

heart rate.

• Because treatment protocols based on the patient’s

blood pressure may rely on specific values and differing

measurement methods, such as auscultatory, clinicians

should note a possible variance from values obtained

with the PRO Monitor in planning patient care

management. The PRO Monitor values are based on the

oscillometric method of noninvasive blood pressure

measurement and correspond to comparisons with intra-

aortic values within ANSI /AAMI Standards for accuracy

(a mean difference of ± 5 mmHg, and a standard

deviation of ± 8 mmHg).

• Several conditions may cause the BP parameter to

calculate and display only the mean arterial pressure

(MAP) without a systolic and diastolic reading. These

conditions include very low systolic and amplitude

fluctuations, so an accurate calculation for these values

can’t be made (e.g., patient in shock); too small of a

difference between systolic and MAP calculations in

relationship to the difference between diastolic and

MAP; or a leak has occurred in the PRO Monitor

(1. Check all BP connections 2. Monitor may need

calibration and leak testing). If only the MAP value is

displayed, the systolic and diastolic will display dashes

(---) and an alarm message “N99-BP FAILED” will be

displayed.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 107 108

Keine Kommentare

Dinamap Pro 100V2 Spezifikationen Seite 26